Skip to Main Content Skip to Main Navigation

Lobster & Crab


Lobster is one of the most important fisheries in New Hampshire’s marine waters. The following is a summary of licensing requirements, and fishing and gear regulations for the harvest of lobster and crab.


A license is required to take lobsters and crabs. Federal license required to fish in waters seaward of state waters. The more restrictive measure applies when fishing more than one management area.

Legal length

No lobster less than 3¼ inch carapace length, whether alive or dead, may be transported, bought, sold, given away, exposed for sale or possessed. No lobster greater than 5 inches carapace length may be possessed by any person holding a N.H. License to Take Lobsters (RSA 211:18).

How to measure a lobster

measuring a lobster photo.tif

Measurements must be made from the rear of the eye socket, along a line parallel to the center line of the body shell, to the rear of the body shell. When lobster meat is removed from the shell, the tail meat must be whole, intact and not less than 4¼ inches, when laid straight and measured end to end (not including the small part that is on the body end of the tail meat). Possession of mutilated lobster, cooked or uncooked, will be prima facie evidence that they are not of legal length.

Lobster meat from outside the state must meet the minimum length requirements. Hermetically sealed cans of lobster, not requiring refrigeration and not weighing over 8 ounces net, are exempt from this provision.


No person can remove spawn from any female lobster or take, serve, have in his possession, sell or offer for sale any female lobster carrying spawn or any lobster spawn.

Female lobsters

No person can take, buy, sell, or possess any female lobster bearing eggs. Female egg-bearing lobsters must be immediately returned alive to the waters from which taken. This does not apply to lobsters spawning in holding cars or pounds if, upon discovery, they are liberated alive in the coastal waters (call Fish and Game Law Enforcement at (603) 271-3361 when discovered).


lobster V-notch photo.tif

Any female possessing a V-notched (notched right flipper next to the middle flipper when underside of female is down and its tail toward you) or mutilated right flipper must be immediately returned to the waters from which it was taken (zero tolerance). All commercial and limited commercial lobster licensees shall immediately V-notch and return to the water, all egg-bearing female lobsters captured in the process of taking lobster.

Lobster Fishing


No closed season

Fishing Time

1 hour before sunrise to sunset

Minimum Size

3¼ inch carapace length

Maximum Size

5 inch carapace length

Tail Meat Length

4¼ inch (must be cooked)


  • Egg bearing females must be V-notched
  • V-notched lobsters are illegal to possess
    (zero tolerance)

Egg Bearing Females

Illegal to possess


Illegal to possess

permitted vessels—
Non-Trap Limits

  • 100 lobsters per day
  • Maximum of 500 lobsters per single trip 5 days or more
  • 100 lobsters for any fishing trip when the duration of the trip in number of hours cannot be documented by the Department

Crab Fishing


License required to take more than 12, or by trap

Daily Limit
without License

12 rock or Jonah crabs by hand only

Daily Limit
with License

No limit

Green Crabs

May be taken in any quantity by any legal method

Lobster trap tags

Persons taking lobsters by trap are required to purchase trap tags up to the maximum allowed by their license (1,200 for commercial; 600 for limited commercial if license held prior to January 1, 2006; 100 for new limited commercial harvesters; 5 for recreational). Additional trap tags are allowed for routine trap losses. Lobster trap tags are valid for one year (June 1 – May 31 of the following calendar year). A valid lobster trap tag shall be securely attached to the frame of the lobster trap in a manner for which it was designed. For more detailed information, contact Fish and Game’s Region 3 office, (603) 868-1095.

How to Order Trap Tags

  • Trap tags are not based on a calendar year. Trap tags are valid from June 1 – May 31.
  • The new year tags must be affixed to traps by June 1.
  • Trap tags can take up to 8 weeks to receive after ordering.
  • Recreational tags are ordered through N.H. Fish and Game Licensing Office — (603) 271-3422.
  • All commercial and federal trap tags must be ordered through the Department’s selected vendor.
  • Order forms are available on the N.H. Fish and Game website or from the Department’s Region 3 office after March 15.
  • New order forms are sent out to previous licensees by March each year.
  • Any questions relating to trap tag orders must go through the Region 3 office (603) 868-1095 – not the vendor.

Did You Know?

Lobsters may not be taken by diving, angling, spearing or dipping.

Lobster Gear

Lobsters shall only be taken by traps in state waters.

Lobster Gear Requirements


No more than 22,950 cubic inches

Escape Vent Size
(in parlor section)

At least 11516 inches x 5¾ inches or two circular vents at least 2716 inches in diameter; see other options below

Escape Panels
(in parlor section)

  • Hinged at the top of positively buoyant or bottom of negatively buoyant panels
  • Tied with an untreated natural fiber not to exceed 3/16 inches in diameter OR nonstainless, uncoated, ferrous metal wire not exceeding 3/32 inches in diameter
  • Opening must be at least 3¾ inches by 3¾ inches when open or removed
  • See further details below

Runners or Sills

Must have at least 2 running the length of the bottom of the trap

Weak Links

600-pound breaking strength seaward of harbors (see Tide Tables)


Sinking if seaward of the harbors (see Tide Tables)

Trap and Trap
Tag Limits

  • Depending on license type: recreational (5 traps), or commercial (100, 600, or 1200 traps)
  • Season runs June 1 – May 31
  • New tags must be affixed by June 1

Escape vents or gaps

Must be in the parlor section of the trap and may be:

  1. A rectangular or oblong escape vent at least 11516 inches by 5¾ inches, located next to the bottom edge;
  2. Two circular vents at least 2716 inches in diameter;
  3. A gap created by raising, modifying or separating the horizontal or vertical laths so that they create openings as described in 1) or 2) above;
  4. A gap caused by separating both ends of 2 laths 1¾ inches on the top of the parlor section next to the middle bow or supporting frame and directly over the parlor head; or
  5. Vents cut in the side or the end of a wire or plastic trap that comply with the dimensions in 1) and 2) above.

Biodegradable escape panels and runners

Each trap must have escape panels and at least two runners or sills extending the entire length of the trap. Nothing may be placed in the parlor section of the trap that will obstruct the opening after disintegration of the fiber. The traps must be constructed in the following manner:

  • Rectangular wire or plastic mesh traps:
    1. Every trap must have at least 2 parallel runners or sills attached to the bottom of the trap, running along the entire length of the exterior.
    2. Every trap must have an unobstructed escape panel which must be:
  • Located in the parlor section on the sides or end;
  • Hinged at the top of positively buoyant panels or at the bottom of negatively buoyant panels;
  • Tied with an untreated natural fiber such as cotton, sisal, hemp or jute not exceeding 3/16 inches in diameter before immersion in sea water, or a piece of nonstainless, uncoated ferrous metal wire not exceeding 3/32 inches in diameter; and
  • Of sufficient size to create an opening of at least 3¾ inches x 3¾ inches when the panel is removed or opened.
  • Non-rectangular wire or plastic mesh traps:

Must have at least two runners and an escape panel which will create an opening of 3¾ inches x 3¾ inches when open. These construction designs must be approved in writing by the Fish and Game Director.

  • Wood lath traps—half round, round or rectangular:

Every trap must have at least two runners and an escape panel. An escape panel can be created by one untreated, softwood lath running the full length of the parlor section. The lath must have the same dimensions as the other laths on the trap. It must not be located where it will rest on the sea bottom. After disintegration, it must leave a space of at least 3¾ inches x 3¾ inches between the adjacent laths. One can also be created by an opening of at least 3 inches between adjacent laths, running the length of the parlor section, which is laced with an untreated natural fiber such as cotton, sisal, hemp, or jute not exceeding 3/16 inches in diameter before immersion in sea-water.

Note: The Fish and Game Director may exempt specific trap designs from the escape vent and escape panel requirements if it can be conclusively proven that the specific trap design will only take crabs and is incapable of catching lobster. Approval will be granted in writing only after inspection.

Gear Marking

Each lobster or crab license holder has a color scheme or special markings indicated on their license. These must be used to mark all buoys. These colors must also be displayed on the boat, either by painting an area at least 1 square foot on the port and starboard side of the bow or by setting a painted buoy on the highest point of the boat (excluding the mast) visible for 360 degrees. The buoy or colors must be permanently attached at all times while the lobster or crab gear is being fished.


Gear Marking Requirements

All Fixed Gear

  • Permanently marked with the owner’s name
  • Flags and pennants affixed to buoys marking a string of gear must be of uniform color

Pot or Trap Trawls

If 5 or more traps or pots, must be marked with buoys made of highly visible material set on both ends of the trawl

Lobster Buoy

Last name and initials, permanently marked (carved or branded); 2 buoys per 5 or more trap trawls

Lobster Trap

Last name and initials, permanently marked (carved or branded)

Lobster Car

Last name and initials; permanently marked (carved or branded)

Leave Lobster Pots Alone

Lobster pots, traps, warps (ropes), cars or buoys are private property, regardless of the location. This includes on the beach and in the rocks. No person except the owner or a conservation officer can possess, lift, molest or disturb them. To do so can result in a fine of $2,000 and up to 1 year in jail.

Did You Know?

If you have a lobster license, you are required to report catch and effort information. For more information, call Marine Fisheries Division at 603-868-1095.

Regulations in red are new this year.

Purple text indicates an important note.

Return to the home page
Conservation Partner Advertisements: The allows appropriate advertising in its annual regulation guides in print and online, in order to defray or eliminate expenses to the state, and support enhanced communications with Constituents. Through a unique partnership with J.F.Griffin Publishing, LLC &, ‘Conservation Partners’ have been established that pay for advertising in support of the regulations both in print and online. The neither endorses products or services listed or claims made; nor accepts any liability arising from the use of products or services listed. Advertisers interested in the Conservation Partners program should contact J.F.Griffin/ directly at 413-884-1001,
J.F. Griffin reaches 20 million sportsmen every year through our print and digital publications. We produce 47 hunting and fishing regulation guides for 22 state agencies.
For advertising information, please visit: